This paper proposes the new cable-type EPS (Electronic Power Steering) system with an active steering torque control using the driving diagram. This diagram expresses a state of vehicle motion when a driver steers, using the front wheel angle and difference between front wheel side slip angle and rear wheel side slip angle. The torque control applies the steering torque to lead the vehicle motion for a stable state utilizing the driving diagram As simulation results, effectiveness of corrective steering assisted by the active controlled steering torque in this EPS system for recovery from spinning on a slippery road surface has been clarified.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Proposal on variable gear ratio characteristics of cable-type EPS with active torque control in over-steer situation


    Beteiligte:
    Sakai, Katsuhiro (Autor:in) / Yoneda, Atsuhiko (Autor:in) / Shimizu, Yasuo (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2004


    Format / Umfang :

    10 Seiten, 13 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Proposal on variable gear-ratio characteristics of cable-type EPS with active torque control in over-steer situation

    Sakai, K. / Yoneda, A. / Shimizu, Y. et al. | British Library Conference Proceedings | 2004


    Steer-by-wire control method with variable transmission ratio

    LIU WEI / ZHANG QINGJIE / YU SHUISHENG et al. | Europäisches Patentamt | 2022

    Freier Zugriff

    GEAR DRIVE AND DRIVE WHEEL CONFIGURATION FOR ZERO TORQUE STEER

    WHITE ANDREW / STENT MARK / COLE MALCOLM | Europäisches Patentamt | 2020

    Freier Zugriff

    GEAR DRIVE AND DRIVE WHEEL CONFIGURATION FOR ZERO TORQUE STEER

    A WHITE / STENT MARK / COLE MALCOLM | Europäisches Patentamt | 2020

    Freier Zugriff