Waste streams of three automotive remanufacturers were analyzed to determine factors that impede the reuse of parts. The eventual goal of this work is to enable the design of products that facilitate reuse. Remanufacturers disassemble and clean used products, replace or repair failed parts, and reassemble products in a production-batch process. Although design that facilitates any of these steps benefits remanufacture, the essential goal of remanufacture is to reuse parts. Parts not reused enter the waste stream. Worn parts that could not be further refurbished were found to constitute the highest contribution to the waste streams of the remanufacturers studied.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Supporting design for remanufacture through waste-stream analysis of automotive remanufacturers


    Weitere Titelangaben:

    Entwurfsunterstützung für die Wiederaufarbeitung durch Analyse der Abproduktströme von Kraftfahrzeugregenerierungsunternehmen


    Beteiligte:
    Sherwood, M. (Autor:in) / Shu, L.H. (Autor:in) / Fenton, R.G. (Autor:in)

    Erschienen in:

    CIRP Annals ; 49 , 1


    Erscheinungsdatum :

    2000


    Format / Umfang :

    4 Seiten, 1 Bild, 3 Tabellen, 7 Quellen





    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    FMEA-based design for remanufacture using automotive-remanufacturer data

    Lam,A. / Sherwood,M. / Shu,L.H. et al. | Kraftfahrwesen | 2001


    FMEA-Based Design for Remanufacture Using Automotive-Remanufacturer Data

    Lam, A. / Shu, L. H. / Sherwood, M. | SAE Technical Papers | 2001