A new method for extracting accurate stress information from reduced-order structural and aeroelastic models is presented. The method has second-order accuracy when approximate reduced-order direct and adjoint solutions (based on different reduced-order bases) are used simultaneously to obtain approximate stresses. The method is applicable to both static and dynamic linear analysis. A review of four common methods for structural model order reduction [two variants of the mode displacement method (standard mode displacement and the fictitious mass method), the mode acceleration method, and the Ritz vector method] identifies sources of difficulty and causes of errors in stress behavior sensitivity calculations. Considerations used for selection of the reduced-order direct and adjoint bases are discussed. A series of static and dynamic test cases is used to assess accuracy of the new method in an analysis mode. Accuracy studies of sensitivity calculations follow. The authors hope to contribute to the field of design-oriented structural dynamics in terms of both insight and practice.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Reduced-order design-oriented stress analysis using combined direct and adjoint solutions


    Weitere Titelangaben:

    Entwurfsorientierte Spannungsanalyse von reduzierter Ordnung unter Nutzung der Kombination von direkter und adjungierter Lösung


    Beteiligte:
    Livne, E. (Autor:in) / Blando, G.D. (Autor:in)

    Erschienen in:

    AIAA Journal ; 38 , 5 ; 898-909


    Erscheinungsdatum :

    2000


    Format / Umfang :

    12 Seiten, 11 Bilder, 37 Quellen




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch