At the Tenth ESV Conference, MVMA (Motor Vehicle Manufacturers Association) reported on the development ofa component side impact test device developed for MVMA by MGA Research Corporation. Since that time, the test device has been modified by MGA to improve its biofidelity. Testing has shown that the modified device better meets the force-time corridors derived by MVMA from cadaver drop test data. The improved test device was used to test twelve 1985 Ford LTD doors at speeds of 25.7 and 37 km/h. The interior door surfaces were trimmed with either thin fiber board or foam padding identical to doors in vehicles tested by MVMA using NHTSA's full-vehicle test procedure. The tests showed that the MVMA device is simple to set up and run, is highly repeatable and easily discriminates between the unpadded and padded doors. A major issues for future research and development is how to select a priori a component test device impact speed which can account for differences in car size and side structure stiffness.
Status and update of MVMA component testing
Stand und Ergaenzungen zu den MVMA-Versuchen fuer einzelne Teile
SAE-Papers ; May ; 1-12
1987
12 Seiten, 14 Bilder, 8 Tabellen, 7 Quellen
Aufsatz (Konferenz)
Englisch
Status and Update of MVMA Component Testing
SAE Technical Papers | 1987
|The MVMA Gas Generants Investigation
Kraftfahrwesen | 1979
|The MVMA Gas Generants Investigation
SAE Technical Papers | 1979
|The MVMA Two-Dimensional Crash Victim Simulation
SAE Technical Papers | 1974
|Graphics and Animation Related to MVMA-2D Model
Kraftfahrwesen | 1984
|