This report describes the results of testing the Kat's Engine Block Heater with respect to exhaust emissions and fuel economy at ambient temperatures of 20 degrees, 40 degrees, and 60 degrees Fahrenheit. This device contains an electric heating element within an open metal cylinder which is spliced into the lower radiator hose of the engine's cooling system. The primary purpose of this device is to minimize hard starting in cold weather. A secondary purpose is to improve fuel economy. Testing of three 1979 passenger cars was conducted at EPA's Motor Vehicle Emission Laboratory from December 1981 through March 1982. The test sequence used was the Federal Test Procedure (FTP). The test results varied between test vehicles although some definite improvements in HC and CO were noted at the lower temperatures. Minor improvements in fuel economy were found during the warm-up period. As the test temperatures were increased, the amount of change caused by the device was reduced. Vehicle start-up and driveability were essentially unchanged throughout the program.
Emissions and fuel economy of the Kat's engine block heater device
Schadstoffemission und Kraftstoffverbrauch bei Anwendung des Kat-Vorwaermers fuer den Motorblock
US Government Reports ; Okt ; 1-14
1982
14 Seiten
Report
Englisch
Diesel engine fuel economy, emissions and noise
Kraftfahrwesen | 1977
|The Orbital Ultra Low Emissions and Fuel Economy Engine
Tema Archiv | 1993
|The Orbital Ultra Low Emissions and Fuel Economy Engine
Kraftfahrwesen | 1993
|Optimizing Engine and Car Design for Fuel Economy and Emissions
SAE Technical Papers | 1976
|