With the introduction of the rotary forge at the Watervliet Arsenal, a new line of inspection equipment was required. The need to design inspection equipment to measure hot cannon tubes in the ' as forged' condition created gaging problems not often encountered in industry. Forgings must be inspected immediately off the forging machine to monitor uniformity of waIl thickness. Any tendency toward excessive wall thickness variation must be detected immediately and corrective measures taken. The rate of forge operation could result in the production of many rejectable tubes if inspection was delayed until the forging cooled. The inspection system required development of a new application technique for ultrasonics. Hydraulic pressure is used to bringtransducers in contact toard excessive wall thickness variation must coupling between the transducer and the forging. Wall thickness measurements are taken simultaneously at four positions around the tube circumference and a wall thickness variation at that cross-section is printed out. (DePo)


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Hot wall thickness variation measurement system


    Weitere Titelangaben:

    Messung der Wandtemperatur bei geschmiedeten Geschuetzrohren


    Beteiligte:
    Krupski, S.J. (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    1979


    Format / Umfang :

    29 Seiten


    Medientyp :

    Report


    Format :

    Print


    Sprache :

    Englisch