In a drive-by-wire steering system for the disabled driver, the safety of the system depends on the reliability of the electronic components. There is however another constraint, that of cost. A microprocessor-based system appears to be the most appropriate type. It was found however that three independent channels were needed to get the required level of reliability. The prototype system described here illustrates some of the problems and some of the potential solutions. Important among these is the balancing of the computations between the parallel channels.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Reliable microprocessor control for drive-by-wire car steering for the disabled


    Weitere Titelangaben:

    Zuverlaessige Mikroprozessorsteuerung zur Lenkung von Behindertenfahrzeugen


    Beteiligte:
    Haynes, N.A. (Autor:in) / Moore, W.R. (Autor:in) / Martin, A.G. (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    1982


    Format / Umfang :

    6 Seiten, 10 Quellen



    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch




    Microprocessor control system for the torque drive of a steering mechanism

    Domanov, V.I. / Domanov, A.V. | Tema Archiv | 2001


    Drive-by-wire steering wheel assembly, drive-by-wire steering device and vehicle

    QIN TAO | Europäisches Patentamt | 2023

    Freier Zugriff

    A Drive-By-Wire Vehicle Control System for Severely Disabled Drivers

    Flaver,J.L. / Penoyre,S. / Stoneman,B.G. et al. | Kraftfahrwesen | 1976