For test specimens built up symmetrically from 16 layers of fiber reinforced material the stress distribution are calculated under axial and thermal loads. Though the stresses are assumed constant in the axial direction volume elements are necessary to include interlaminar shear and peeling stresses. But the number of degrees of freedom and the bandwidth of the system matrix can be kept relatively low. The results show quite distinct stress peaks at layer interfaces, and it was found that even with 16 quadratic elements over the layer thickness these values have not reached an acceptable accuracy. The convergence behavior gives rise to the conjecture, that infinite stresses may occur at those points. Making use of the substructure technique a few examples with different stacking sequences were analyzed. The results are compared to obtain a set-up with small edge stresses.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    On the determination of edge stresses in layered composites


    Weitere Titelangaben:

    Ueber die Bestimmung von Randspannungen in geschichteten Verbundwerkstoffen


    Beteiligte:
    Rohwer, K. (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    1982


    Format / Umfang :

    9 Seiten, 12 Bilder, 19 Quellen



    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch





    AIAA-2001-1573 Experimental Investigation of Free Edge Residual Stresses in Layered Materials

    Bowman, K. / Mollenhauer, D. / American Institute of Aeronautics and Astronautics | British Library Conference Proceedings | 2001




    Knife-edge materials and stresses

    Van Kuren, H.L. | Engineering Index Backfile | 1917