Pantograph hardware-in-the-loop (HIL) testing is an experimental method in which a physical pantograph is excited by an actuator which reproduces the movement of a virtual catenary. This paper proposes a new method that uses analytical catenary models for HIL tests. The approach is based on an iterative scheme until achieving a steady-state regime. Some of the method's advantages include its ability to consider the delay in the control and communication system and its applicability to a wide range of analytical catenary models. The proposed algorithm was validated both numerically and experimentally. The experimental results obtained in the HIL pantograph tests were compared with those obtained from pure numerical simulations using a linear pantograph model and showed good accuracy with pantograph running at different speeds.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Hardware-in-the-loop pantograph tests using analytical catenary models


    Beteiligte:
    Gil, J. (Autor:in) / Tur, M. (Autor:in) / Correcher, A. (Autor:in) / Gregori, S. (Autor:in) / Pedrosa, A. (Autor:in) / Fuenmayor, F. J. (Autor:in)

    Erschienen in:

    Vehicle System Dynamics ; 60 , 10 ; 3504-3518


    Erscheinungsdatum :

    2022-10-03


    Format / Umfang :

    15 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Unbekannt




    Real-time catenary models for the hardware-in-the-loop simulation of the pantograph–catenary interaction

    Facchinetti, A. / Gasparetto, L. / Bruni, S. | Taylor & Francis Verlag | 2013


    Real-time catenary models for the hardware-in-the-loop simulation of the pantograph-catenary interaction

    Facchinetti,A. / Gasparetto,L. / Bruni,S. et al. | Kraftfahrwesen | 2013



    Pantograph/Catenary Systems

    Shabana, Ahmed | Wiley | 2021