A study of elastic lateral distortional buckling of cantilever monosymmetrical I-beams is presented. The method assumes that the flange cross-sections remain straight (undistorted) during buckling, but that the web is free to distort. Three different load patterns are considered: an end moment load, a uniformly distributed lateral pressure and an end point load. The study applied a Rayleigh–Ritz method that the authors previously developed for simply supported beams to cantilevers. The accuracy of the method is verified by comparing the results with a general finite element linear buckling analysis, using NX/Nastran. The method offers advantages over commonly used finite element analysis because it is mesh-free and requires only 6 × n degrees of freedom; therefore, the solution process is rapid and suitable for design space exploration. For doubly symmetric I-beams, a cubic transverse normal stress distribution, derived from the equation of equilibrium, was used in the total potential energy. The results were compared to the previous method which used a linear stress distribution.
Elastic lateral distortional buckling analysis of cantilever I-beams
Ships and Offshore Structures ; 8 , 3-4 ; 261-269
2013-06-01
9 pages
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
Elastic lateral distortional buckling analysis of cantilever I-beams
Online Contents | 2013
|Elastic lateral torsional buckling strength of monosymmetric stepped I-beams
Online Contents | 2012
|Elastic lateral torsional buckling strength of monosymmetric stepped I-beams
Springer Verlag | 2012
|The lateral buckling of deep beams
TIBKAT | 1931