Abstract The effect of compressive strength and expansion rate of filler grout on bond behavior of grouted pipe splice is discussed. Three types of grout were designed and utilized to prepare coupler specimens as filler material. The compressive strength ranged from 67.5 to 91.8 MPa. The volume expansion rate changed from -0.023% to -0.037% under airtight curing condition, and from 0.027% to 0.057% under water curing condition, respectively. Based on pullout test, it was found that the bond strength and stiffness of grouted splice both improve with the increment of the expansion rate due to the increased initial confinement. By experimentally measuring the exterior surface transverse strain of grouted sleeve in curing stage, the confinement and its influencing factor on bond performance were derived. The confinement increases nonlinearly with the increment of grout shell thickness and sleeve radial stiffness other than grout expansion rate. The diameter-thickness ratio of sleeve should not exceed 13 to avoid a possible debonding failure at bar-grout interface. Utilizing the calculated confining pressures, the bond strength of the grouted splice was determined and compared with pullout test result, which shows a good agreement.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Effect of Grout Properties on Bond Behavior of Grouted Pipe Splice


    Beteiligte:
    Zheng, Yongfeng (Autor:in) / Guo, Zhengxing (Autor:in) / Zhang, Xin (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2017-12-12


    Format / Umfang :

    10 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Effect of Grout Properties on Bond Behavior of Grouted Pipe Splice

    Zheng, Yongfeng / Guo, Zhengxing / Zhang, Xin | Online Contents | 2018


    Freeze—Thaw Behaviours of Half Grouted Sleeve Connections with High-Performance Grout

    Zhu, Haiqing / Cheng, Zhang / Wu, Zhaoyue et al. | Springer Verlag | 2022


    Bond fixture composite splice fairing assembly

    LOFSTROM SVEN ROY / LITTLEJOHN DAVID / SMITH SCOTT OREN | Europäisches Patentamt | 2019

    Freier Zugriff

    Bond fixture for composite splice fairing assembly

    LOFSTROM SVEN ROY / LITTLEJOHN DAVID / SMITH SCOTT OREN | Europäisches Patentamt | 2022

    Freier Zugriff

    Bond fixture for composite splice cap assembly

    LOFSTROM SVEN ROY / LITTLEJOHN DAVID / BOYLE ERIC | Europäisches Patentamt | 2022

    Freier Zugriff