Increase in demand for power in the world has intensified the need for renewable energy power resources due to the scarcity of non-renewable power sources. Solar power is gaining popularity as it is ecofriendly, portable and clean. Isolated DC–DC converters are popular in a wide range of applications. High efficiency, conversion ratio and isolation between the low- and high-voltage circuit are the main features of the isolated converter. This paper proposes design, modeling and simulation of the push–pull converter in MATLAB/Simulink. The design procedure and principle of operation are also presented in the paper. The state space averaging technique is used to model the converter, and Bode plot is used to design a PI controller to obtain the required output voltage.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Modeling and Analysis of 1.2 kW, 36–375 V, Push–Pull Converter


    Weitere Titelangaben:

    Lect. Notes Electrical Eng.


    Beteiligte:
    P., Sanjeevikumar (Herausgeber:in) / Prabhu, Nagesh (Herausgeber:in) / K., Suryanarayana (Herausgeber:in) / Adappa, Raksha (Autor:in) / Suryanarayana, K. (Autor:in)


    Erscheinungsdatum :

    2021-08-21


    Format / Umfang :

    15 pages





    Medientyp :

    Aufsatz/Kapitel (Buch)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Capacitive-loaded push-pull parallel-resonant converter

    Edry, D. / Ben-Yaakov, S. | IEEE | 1993


    Modeling and Analysis of 1.2 kW, 36-375 V, Push-Pull Converter

    Adappa, Raksha / Suryanarayana, K. | TIBKAT | 2022



    Capacitive-loaded push-pull parallel-resonant converter

    Edry, D. / Ben-Yaakov, S. | Tema Archiv | 1993


    Bidirectional push-pull mechanism, bidirectional push-pull table board and bidirectional push-pull storage device

    CUI KEMAN / YE JIANHUI / LI CHONG | Europäisches Patentamt | 2023

    Freier Zugriff