This paper presents the general influence of feed rate on residual surface stresses of carbon steel in high-feed face milling. Residual stresses were measured using the X-ray diffraction technique. The feed per tooth was realised up to 8 mm per tooth. It was conducted that tensile residual stresses are generated when high-feed face milling. Increasing feed rate leads to higher tensile surface residual stresses in the face milling of carbon steel.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Surface Residual Stresses in High-Feed Face Milling of Carbon Steel


    Weitere Titelangaben:

    Lect.Notes Mechanical Engineering


    Beteiligte:
    Jármai, Károly (Herausgeber:in) / Cservenák, Ákos (Herausgeber:in) / Borysenko, Dmytro (Autor:in) / Kundrák, János (Autor:in) / Karpuschewski, Bernhard (Autor:in) / Welzel, Florian (Autor:in) / Maros, Zsolt (Autor:in) / Felhő, Csaba (Autor:in)

    Kongress:

    Vehicle and Automotive Engineering ; 2022 ; MISKOLC, Hungary September 08, 2022 - September 09, 2022



    Erscheinungsdatum :

    2022-09-10


    Format / Umfang :

    6 pages





    Medientyp :

    Aufsatz/Kapitel (Buch)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Probabilistic Prediction of Burr Patterns of 1045 Carbon Steel in Face Milling

    Park, I. W. / Ahn, S. / Dornfeld, D. A. | British Library Online Contents | 2002



    Preliminary Investigations for the Effect of Cutting Tool Edge Geometry in High-Feed Face Milling

    Karpuschewski, Bernhard / Kundrák, János / Felhő, Csaba et al. | TIBKAT | 2018


    Distortion and Residual Stresses in Nitrocarburized and Carbonitrided SAE 1010 Plain Carbon Steel

    Northwood, Derek O. / Bauerle, Peter / Bowers, Randy et al. | SAE Technical Papers | 2008