This paper presents the results of research on the behavior of preflex beam considering manufacturing process. A series of test-specimen were made and tested, which included the traditional preflex beam, preflex beams with additional shear connectors above the bottom flange and the beams with some shear keys. The test results are compared with the values given in the design code and analytical results using finite element method with 3-D model. Time dependent effects are also estimated and compared with the values given in design code. It is found that the effects of residual stress in steel girder are greater than expected, which results in more loss of camber, and the produced stress due to shrinkage of casing concrete are far greater than the values given in design code, which may cause the tension cracks in casing concrete of bottom flange. Based on the results of the study, a few proposals are made for improving the quality and durability of preflex beam.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Behavior of preflex beam in manufacturing process


    Weitere Titelangaben:

    KSCE J Civ Eng


    Beteiligte:
    Bae, Doobyong (Autor:in) / Lee, Kwang-Myong (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2004-01-01


    Format / Umfang :

    5 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Floor boundary beam and manufacturing process thereof

    GAO SHUANGMING / CHEN SHITAO / RUAN LINFAN et al. | Europäisches Patentamt | 2021

    Freier Zugriff

    Vehicle pipe cross beam assembly and manufacturing process thereof

    ZHANG SHUYING / LIU HUANLIANG / HAN QINGXIN et al. | Europäisches Patentamt | 2021

    Freier Zugriff

    TORSION BEAM MANUFACTURING METHOD, TORSION BEAM MANUFACTURING DEVICE, AND TORSION BEAM

    IGUCHI KEINOSUKE / MIZUMURA MASAAKI | Europäisches Patentamt | 2019

    Freier Zugriff

    TORSION BEAM MANUFACTURING METHOD, TORSION BEAM MANUFACTURING DEVICE, AND TORSION BEAM

    IGUCHI KEINOSUKE / MIZUMURA MASAAKI | Europäisches Patentamt | 2017

    Freier Zugriff

    GMT rear anti-collision beam and manufacturing process thereof

    XIE XIN | Europäisches Patentamt | 2020

    Freier Zugriff