This study is to analyze the spray characteristics near the nozzle according to the cavitating flow and step-hole structure using a quartz nozzle simulating a gasoline direct injection (GDI) injector. Referring to the dimensions of the injector used in mass-produced vehicles, various step-hole and injection pressure conditions were used in this experiment. Based on the injector dimensions, the step-hole conditions were designed in the direction of decreasing the depth and diameter. The internal flow in nozzle and spray near the nozzle were visualized by the shadow graphic and Mie-scattering visualization technique. A solenoid valve was used to simulate fuel injection like injector. Basically, the tendency of cavitating flow and spray characteristics were analyzed under various step-hole conditions. In addition, the tip wetting of nozzle with different step-hole conditions was analyzed, and the nozzle tip wettings at initial injection and end of the injection were separated and compared in detail. It was found that the wetting intensity decreased reduced 44.9 % when reduce step-hole depth from 2.5 to 1.5 mm. Tip wetting mainly occurred at initial injection for most step-hole conditions, but the tip wetting at end of injection was dominant when both decreasing the step-hole depth and step-hole diameter.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Characteristics of Spray Near the Nozzle and Tip Wetting in an Enlarged GDI Injector Step-Hole Nozzle


    Weitere Titelangaben:

    Int.J Automot. Technol.


    Beteiligte:
    Kim, Byunggyun (Autor:in) / Chang, Mengzhao (Autor:in) / Park, Suhan (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2023-02-01


    Format / Umfang :

    12 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Nozzle Tip Wetting in GDI Injector and Its Link with Nozzle Spray Hole Length

    Xiao, Di / Zhang, Fuhao / Li, Kaixiang et al. | SAE Technical Papers | 2022


    Nozzle Tip Wetting in GDI Injector and Its Link with Nozzle Spray Hole Length

    Li, Kaixiang / Xiao, Di / Zhang, Fuhao et al. | British Library Conference Proceedings | 2022


    Development of Multi-hole Nozzle Injector for Spray-guided DISI Engine

    Tanaka, Makoto / Shigenaga, Masahiro / Yamamoto, Norio et al. | SAE Technical Papers | 2011


    Numerical Investigation of GDI Injector Nozzle Geometry on Spray Characteristics

    Weall, Adam / Jing, Daliang / Srivastava, Dhananjay Kumar et al. | SAE Technical Papers | 2015


    Fuel Spray Pattern Control Using L-Step Nozzle for Swirl-Type Injector

    Abe, Motoyuki / Ishikawa, Toru / Okamoto, Yoshio et al. | SAE Technical Papers | 2004