Heat flux measurement and pressure-based heat release analysis have been performed on a spray-guided direct-injection spark-ignition single-cylinder research engine. A two-dimensional model of the heat flux sensor has been used to calculate the heat flux from the measured surface temperature. The effects of the ignition timing, air-fuel ratio, and mixture preparation on the engine heat flux and heat release have been investigated at a specific operating condition. An engine thermodynamic simulation code has been used to predict the gas-to-wall heat transfer using different heat transfer correlations. It was found that both the heat release rate and the heat flux are strongly influenced by ignition timing and air-fuel ratio. The results also show that late direct injection has a faster initial burn rate even compared with the plenum injection mode. The modelled heat transfer has been compared with the measured results and a modified Woschni correlation has been proposed.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Heat release and heat flux in a spray-guided direct-injection gasoline engine


    Beteiligte:
    Wang, X (Autor:in) / Price, P (Autor:in) / Stone, C R (Autor:in) / Richardson, D (Autor:in)


    Erscheinungsdatum :

    01.11.2007


    Format / Umfang :

    12 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Heat release and heat flux in a spray-guided direct-injection gasoline engine

    Wang,X. / Price,P. / Stone,C.R. et al. | Kraftfahrwesen | 2007



    Low Emission Combustion for Spray-guided Direct Injection Gasoline Engine

    Miyagawa, H. | British Library Conference Proceedings | 2006


    Spark Discharge Behavior in a Spray-Guided Gasoline Direct Injection Engine

    Tanaka, D. / Sato, K. / Yamamoto, S. et al. | British Library Conference Proceedings | 2009


    Design and development of a spray-guided gasoline direct injection engine

    Chang,W.S. / Kim,Y.N. / Kong,J.K. et al. | Kraftfahrwesen | 2007