This classification for grain size comprises three sets of comparison charts to be used for determining grain size. These charts are presented in three categories as follows: Plate I - Untwinned grains (flat etch) Plate II - Twinned grains (flat etch) Plate IV - Austenite grains in steel (McQuaid-Ehn test or other test) Table 1 lists a number of materials and the comparison charts that are suggested for use in estimating their grain size by the comparison method. NOTEThe suggestions in Table 1 are based upon the customary practices in industry. For specimens prepared according to special techniques, the appropriate comparison chart should be selected on a structural appearance basis as described in the Scope.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Grain Size Determination of Steels


    Erscheinungsdatum :

    1999-05-01



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch



    GRAIN SIZE DETERMINATION OF STEELS

    SAE Technical Papers | 1983


    Determination Of Grain-Size Distributions

    Generazio, Edward R. | NTRS | 1988


    Effective grain size and charpy impact properties of high-toughness X70 pipeline steels

    Hwang, Byoungchul / Kim, Yang Gon / Lee, Sunghak et al. | Tema Archiv | 2005


    Grain Growth Property of Ti-modified Carburizing Steels

    Nishimori, Hiroshi / Hiraoka, Kazuhiko / Hashimoto, Kazuya et al. | SAE Technical Papers | 2005


    Grain Refinement in Hot Rolled Dual Phase Steels

    Mukherjee, K. / Militzer, M. / Hazra, S. | SAE Technical Papers | 2006