This paper describes some computer software developed at Michigan Technological University for the simulation of sheet metal forming which is a large-strain plastic deformation process. The approach taken is not the typical incremental solution approach, where one starts from the flat blank and steps are taken (hopefully) toward the final desired geometry, but a fast interactive one where the known surface geometry is mapped directly back to the flat blank. The strains are then calculated from the geometry change, and calculated strains are compared with experimental strains on a forming limit diagram (FLD) to determine formability.The theory of the deformation process is given in a number of earlier papers. This paper gives example results for several cases of axisymmetric and nonsymmetric geometries.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Computer Simulation of Sheet Metal Forming


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    1985 SAE International Off-Highway and Powerplant Congress and Exposition ; 1985



    Erscheinungsdatum :

    01.09.1985




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Computer simulation of sheet metal forming

    Gerdeen,J.C. / Soper,D.J. / Michigan Technological Univ.,US | Kraftfahrwesen | 1985


    Development of industrial sheet metal forming processes using computer simulation

    Heath,A.N. / Pickett,A.K. / Ulrich,D. et al. | Kraftfahrwesen | 1993


    Process simulation in sheet metal forming

    Makinouchi, A. / Kawka, M. | Tema Archiv | 1994


    93LM054 Development of Industrial Sheet Metal Forming Processes Using Computer Simulation

    Heath, A. N. / Pickett, A. K. / Ulrich, D. et al. | British Library Conference Proceedings | 1993


    Computer-aided modelling of sheet-metal forming

    Kaftanoglu,B. / Darendeliler,H. / Ohio State Univ.,Columbus,US et al. | Kraftfahrwesen | 1993