THE control of residual stresses in automotive cylinder blocks is discussed in this paper. According to the authors, this study was started because a small percentage of castings was being scrapped because of cooling cracks in the valve compartment wall.They discovered that the greatest single factor in inducing trapped stresses in castings is too great a difference in the cooling rates for different portions between 1400 F and 600 F.They also found out that residual tensile stresses can be eliminated in a particular section by keeping its cooling rate at least as fast as that of other significant sections. Moreover, it is possible to move trapped stresses from one section to another by overcooling.They have also developed a method that gives quantitative results that serve as good index values of the trapped stresses present even in complex castings.
Measurement and Control of Residual Stresses in Cylinder-Block Castings
Sae Technical Papers
Pre-1964 SAE Technical Papers ; 1906
1954-01-01
Aufsatz (Konferenz)
Englisch
Residual stresses in as-quenched aluminum castings
Kraftfahrwesen | 2008
|Residual Stresses in As-Quenched Aluminum Castings
SAE Technical Papers | 2008
|Diemaking ingenuity in cylinder block castings
Tema Archiv | 1988
2008-01-1425 Residual Stresses in As-Quenched Aluminum Castings
British Library Conference Proceedings | 2008
|Simulation and measurement of residual stresses for HCF cracks on LPDC aluminium cylinder head
Kraftfahrwesen | 2008
|