This paper presents an investigation into Elastohydrodynamic (EHL) modeling of differential hypoid gears that can be used in coupling with Newtonian (or multibody) dynamics to study Noise, Vibration and Harshness (NVH) phenomena, such as axle whine. The latter is a noise of a tonal nature, emitted from differential axles, characterised by the gear meshing frequency and its multiples. It appears at a variety of operating conditions; during drive and coasting, high and low torque loading. Key design targets for differential hypoid gears are improved efficiency and reduced vibration, which depend critically on the formation of an EHL lubricant film. The stiffness and damping of the oil film and friction generated in the contact can have important effects and cannot be neglected when examining the NVH behaviour of hypoid gears.The operating conditions in hypoid gears are usually characterized by high load, relatively low speeds, angled flow and elliptical contact footprint of high aspect ratio. Some extrapolated/empirical equations to estimate friction and film thickness have been reported for moderate loads. However, their use in hypoid gears is questionable. Additionally, the majority of reported numerical models for film thickness and friction have not been applied under such operating conditions. In this paper a numerical model of EHL elliptical point contact has been presented to obtain the EHL film behaviour under the usual range of operating conditions of hypoid gears. Realistic engine torque-speed characteristics are used. For these conditions, the load share per teeth pair contact is in the region of 500-6000N. A suitable method of solution is applied to ease the convergence of the numerical method, namely the distributed line low relaxation effective influence Newton-Raphson method. As the result of the angled direction of the entraining flow in the contact of hypoid gear teeth pairs, this method has been found to be suitable, thus adopted. The geometric and kinematic input data for EHL calculations are calculated using Tooth Contact Analysis (TCA).


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Elastohydrodynamics of Hypoid Gears in Axle Whine Conditions


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    7th International Styrian Noise, Vibration & Harshness Congress: The European Automotive Noise Conference ; 2012



    Erscheinungsdatum :

    2012-06-13




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Hypoid gears

    Witham, W.A. | Engineering Index Backfile | 1937


    High Speed, Automatable Superfinishing of Rear-Axle Hypoid Gears

    Sroka, Gary / Bell, Matthew / Frechette, Michael | SAE Technical Papers | 2012


    High Speed, Automatable Superfinishing of Rear-Axle Hypoid Gears

    Frechette, M. / Sroka, G. / Bell, M. et al. | British Library Conference Proceedings | 2012


    High speed, automatable superfinishing of rear-axle hypoid gears

    Frechette,M. / Sroka,G. / Bell,M. et al. | Kraftfahrwesen | 2012


    New packard line employs hypoid gears in rear axle

    Gillette, L.S. | Engineering Index Backfile | 1926