This work describes the studies performed using finite element analysis models regarding to the development of an automotive suspension inner joint forming and disassemble (pullout) processes using the software MSC.MARC.The simulation performed involves plastic deformation and contact interaction of different parts in order to represent the steps of the assembly process and the inner joint pullout test. The results shown here were validated by confrontation with experimental data and then used to predict the structural behavior along the assembly process. The stress state after assembly and the required load to break down the inner joint (pullout force) had to satisfy specific design requirements.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Inner Joint Forming and Pullout Simulation Using Finite Element Analysis


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    2004 SAE Brasil Congress and Exhibit ; 2004



    Erscheinungsdatum :

    16.11.2004




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Ball Joint Pull Out Simulation using Finite Element Analysis

    Martins, Herbert R. R. / Zucchini, Marcus | SAE | 2006


    GALLEY PULLOUT

    WHITE PAUL | Europäisches Patentamt | 2016

    Freier Zugriff

    Simulation of Fiber Pullout Tests Using a Peridynamic Approach

    Hall, Riley / Guven, Ibrahim | TIBKAT | 2023


    Simulation of Fiber Pullout Tests using a Peridynamic Approach

    Hall, Riley / Guven, Ibrahim | AIAA | 2023