This specification covers established manufacturing tolerances applicable to aluminum-base alloy standard structural shapes. Standard structural shapes are shapes in certain standard alloys, tempers, sizes, and sections such as angles, channels, Tees, Zees, I-Beams, and H-Beams commonly used for structural purposes. These tolerances apply to all conditions, unless otherwise noted. The term "excl" applies only to the higher figure of the specified range. Tolerances in U.S. conventional units are primary; tolerances in SI units are shown as the equivalent of the inch/foot/degree dimensions and are not to be construed as standard for product produced to SI dimensions.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    TOLERANCES Aluminum Alloy Standard Structural Shapes


    Erscheinungsdatum :

    01.05.1973



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch