The CAE analysis revealed that a stamping component required extremely high yield strength steel in order to pass the safety requirements. However, springback with this component could cause assembly distortions.The formability prediction was compared with the actual nominal die stamping for splits and wrinkles. The predicted free state springback was compared to the measurements.A compensated die was engineered based on the springback dimensions of the free state stamping. Morphing the negative residual surface created the dimensional compensation. Then a new compensated die face was created. A CAE prediction was used to confirm and adjust the compensated die using iterations of predictions and corrections.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Springback Compensation for Ultra High Strength Stamping


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Sa, Chung-Yeh (Autor:in) / Zhao, Kunmin (Autor:in) / Geng, Lumin (Autor:in) / Oetjens, Thomas (Autor:in)

    Kongress:

    SAE 2003 World Congress & Exhibition ; 2003



    Erscheinungsdatum :

    2003-03-03




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Springback compensation for ultra high strength stamping

    Geng, L. / Sa, C.Y. / Oetjens, T. et al. | Tema Archiv | 2003


    Springback compensation for ultra high strength stamping

    Geng,L. / Sa,C. / Oetjens,T. et al. | Kraftfahrwesen | 2003


    Volume Morphing to Compensate Stamping Springback

    Wang, Chuantao / LeBlanc, Paul A. / Sarraga, Ramon F. et al. | SAE Technical Papers | 2009


    A Springback Compensation Study on Chrysler 300C Stamping Panels Using LS-DYNA®

    Nagarajarao, Manjunath S. / Zhu, Xinhai / Hu, Yang | SAE Technical Papers | 2008


    Springback control in stamping car body parts

    Maddis, M. De / Basuc, D. / Lombardi, F. | Tema Archiv | 2004