An essential precondition for an effective and reliable control system is the correct parameterization of the controller. In the present paper the way different cutting conditions influence the cutting force, which is used as an indicator of the milling process, is discussed. By use of different radiant depths of cut it is shown in which way the force-feed-correlation factor of the system changes. To determine the system behavior at different process situations a number of milling tests is carried out machining Ti6AlV4 and AlZnMgCu1.5, two typical aerospace alloys. In order to measure the change of the cutting forces, a three component dynamometer is used. The paper closes discussing future prospects and further steps of development.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Controller Parameter Analysis during the Milling of Aerospace Alloys


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    Aerospace Technology Conference and Exposition ; 2009



    Erscheinungsdatum :

    2009-11-10




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Dry Laser Beam Micro-milling (DLBMM) of Aerospace Alloys

    Darwish, Saied Muhammed Hassan / Ahmed, Naveed / Al-Ahmari, Abdulrahman M. | Springer Verlag | 2017


    Under-Water Laser Beam Micro-milling (UWLBMM) of Aerospace Alloys

    Darwish, Saied Muhammed Hassan / Ahmed, Naveed / Al-Ahmari, Abdulrahman M. | Springer Verlag | 2017


    Laser beam micro-milling of micro-channels in aerospace alloys

    Darwish, Saied Muhammed Hassan ;Ahmed, Naveed ;Al-Ahmari, Abdulrahman M.A. | TIBKAT | 2017


    Alloys for aerospace

    Tuominen, S. / Wojcik, C. | Tema Archiv | 1995


    Titanium Alloys for Aerospace

    R. J. Wanhill | NTIS | 1971