This SAE Recommended Practice is intended for hubs and spoke wheels used on Class 6, 7, and 8 truck/truck-tractor non-powered front axles, powered and non-powered rear axles and trailer axles, for which bearing setting is manually adjusted. Assemblies using spacers to control bearing preload and endplay may differ in geometry and bearing componentry. The document was revised to include an additional hub to flange interface that is used in the industry.
Disc Wheel Hub/Spoke Wheel and Axle Interface Dimensions - Truck and Bus
2018-08-08
Aufsatz (Konferenz)
Englisch
Trailers , Buses , Trucks , Axles , Terminology , Fasteners , Seals and gaskets , Wheels , Bearings , Commercial vehicles
Disc Wheel Hub/Spoke Wheel and Axle Interface Dimensions - Truck and Bus
SAE Technical Papers | 2023
Disc Wheel Hub/Spoke Wheel and Axle Interface Dimensions - Truck and Bus
SAE Technical Papers | 2014
Disc Wheel Hub/Spoke Wheel and Axle Interface Dimensions—Commercial Vehicles
SAE Technical Papers | 2004
Wheel End Assembly and Axle Spindle Interface Dimensions - Truck and Bus
SAE Technical Papers | 2020
Wheel End Assembly and Axle Spindle Interface Dimensions - Truck and Bus
SAE Technical Papers | 2014