This SAE Standard includes complete general and dimensional specifications for those types of pipe fittings commonly used in the automotive and other mass production industries where the use of lubricants or sealers is objectionable. The automotive pipe fittings shown in Figures 1 to 17 and Tables 1 to 6 are intended for general automotive and similar applications involving low or medium pressures or in conjunction with automotive tube fittings in piping systems. Although Figure 6 (130138) in SAE J530 is similar to Figure 39 (140138) in SAE J514, the hex dimensions are not the same. Instead of consolidating them, it was proposed to utilize the +0.00 mm (+0.00 in)/−0.5 mm (−0.02 in) tolerance pertaining to the turn diameter W (Figure 39, SAE J514) on diameter E (Figure 6, SAE J530) to eliminate flats. To make sure that a thin wall will not occur, the following equation was used:


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    AUTOMOTIVE PIPE FITTINGS


    Erscheinungsdatum :

    1995-05-01



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    AUTOMOTIVE PIPE FITTINGS

    SAE Technical Papers | 1981


    AUTOMOTIVE PIPE FITTINGS

    SAE Technical Papers | 1994


    Automotive Pipe Fittings

    SAE Technical Papers | 2018


    AUTOMOTIVE PIPE FITTINGS

    SAE Technical Papers | 1993


    AUTOMOTIVE PIPE FITTINGS

    SAE Technical Papers | 1992