This specification covers established manufacturing tolerances applicable to bars, rods, and wire of nickel, nickel alloy, and cobalt alloys ordered to inch-pound dimensions. These tolerances apply to all conditions, unless otherwise noted. The term "excl" is used to apply only to the higher figure of a specified range. AMS2261K results from a Limited Scope Ballot to correct errors in paragraph references for Out of Roundness (7.1).
Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
08.10.2012
Aufsatz (Konferenz)
Englisch
Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
SAE Technical Papers | 2007
TOLERANCES Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
SAE Technical Papers | 1994
Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
SAE Technical Papers | 2006
Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
SAE Technical Papers | 2009
Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
SAE Technical Papers | 2019