The accuracy of an accident reconstruction is dependent upon the availability and quality of relevant data. Often by the time an engineer is asked to reconstruct a traffic accident the only source of scene data is a police report. Important scene data, such as the point of impact and the points of rest of the vehicles, usually are set forth in the police report. Occasionally, however, the points of rest are not indicated in the police report and they can not be determined by other means.In a typical scenario a left turning “target” vehicle is struck on its right side by the front end of a “bullet” vehicle. The vehicles are available for inspection and the configuration of the roadway at the scene has not been altered since the time of the accident. The point of impact is set forth in the police report, however, the points of rest of the vehicles are not specified. No other sources of information regarding the points of rest of the vehicles are available.This lack of data limits the engineering models that can be used to analyze the accident and quantify the impact velocities of the vehicles. The absence of information regarding the postimpact trajectories of the vehicles prevents the modeling of the vehicles as particles and the use of conservation of linear momentum. The CRASH3 linear momentum analysis, which models the vehicles as rigid bodies, is not useable since it also requires the postimpact trajectories of the vehicle to be known. The application of conservation of energy also can not be used as a means to quantify the speeds at impact due to the postimpact kinetic energies of the vehicles being unknown.A method is set forth in this paper that will allow a quantification of the impact velocity of the bullet vehicle. The method is based on the rigid body dynamics of the CRASH3 damage algorithm and analyzes the momentum exchange at impact. The condition of a common velocity occurring at the impulse center of the damage is an essential component of the method. The method requires an estimation of the impact velocity of the target vehicle.The estimated impact velocity, in conjunction with the calculated change of velocity, ΔV̄, of the target vehicle, are used to solve the velocity polygon located at the impulse center of the target vehicle. This provides a quantification of the common velocity vector, V̄common. The common velocity vector is then used, in conjunction with the calculated ΔV̄ of the bullet vehicle, to solve the velocity polygon located at the impulse center of the bullet vehicle. This results In a quantification of the impact velocity vector of the bullet vehicle.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Impact Analysis Based Upon the CRASH3 Damage Algorithm


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    International Congress & Exposition ; 1995



    Erscheinungsdatum :

    1995-02-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Impact Analysis Based Upon the CRASH3 Damage Algorithm

    Neptune, J. A. / Flynn, J. E. / Underwood, H. W. et al. | British Library Conference Proceedings | 1995


    Impact analysis based upon the CRASH3 damage algorithm

    Neptune,J.A. / Flynn,J.E. / Underwood,H.W. et al. | Kraftfahrwesen | 1995



    CRASH3 damage algorithm reformulation for front and rear collisions

    Prasad,A.K. / TRC of Ohio,US | Kraftfahrwesen | 1990


    Differences Between EDCRASH and CRASH3

    Hargens, Randall L. / Day, Terry D. | SAE Technical Papers | 1985