A design criteria is developed for the axial length effect of pressurized multiple layered spiral wound hose with clamped end couplings. Upon application of hydraulic pressure, the hose section in the vicinity of the clamped end is assumed to deform from a right circular cylinder to a truncated cone with constant wire helix angle. The solution obtained from solving equations of equilibrium for a single naturally curved thin rod experiencing small axial deformation is used to piece-together a layer solution which in turn is plied-up to form a complete hose. Continuity of solutions at the interface of the conical and cylindrical regions is enforced. This enabled transition zone length (axial length of cone) to be expressed as function of hose geometry. Both four and six-layered hose with inside diameters 1.0, 1.25, and 2.0 inches (25.4, 31.8, and 50.8 mm) are considered.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    A Theoretical Analysis of Spiral Hose Wire Reinforcement in the Region Near Clamped Hose Couplings


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Breig, W. F. (Autor:in)

    Kongress:

    International Off-Highway & Powerplant Congress & Exposition ; 1990



    Erscheinungsdatum :

    01.09.1990




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Couplings, Hose, Reattachable Screw-On

    SAE Technical Papers | 2013


    Air brake hose dummy couplings

    Engineering Index Backfile | 1896


    Finite Element Analysis of Hydraulic Hose Couplings

    Oliver, Larry / Chandrasekaran, N. / Haisler, Walter E. | SAE Technical Papers | 1986


    HYDRAULIC PIPING HOSE, BRAKE HOSE, AND HOSE MOUTHPIECE

    YAO MANABU / YOKOSUKA SOICHI / SHIMADA RYOHEI et al. | Europäisches Patentamt | 2017

    Freier Zugriff