A radiotracer method has been developed to measure piston ring and cylinder bore wear rates in spark-ignition (SI) engines. The method has sufficient sensitivity to measure ring and bore wear rates in real time during normal operating conditions. This work reports measurements on the rates of break-in and steady-state wear of piston rings and cylinder bores during a variety of engine operating conditions. Results show that piston ring break-in is minimal and that ring wear rates are constant at steady-state engine operation. The key factor affecting ring wear is engine brake mean effective pressure (BMEP). Ring wear behavior is repeatable for a given engine type and between two different engine designs. Cylinder bore wear is dominated by initial break-in, cold-start wear, and changes in operating conditions. Wear of the cylinder bore during steady-state operating conditions is very low when compared to break-in and changes in conditions. Both piston ring and cylinder bore wear rates as measured by the radiotracer method are reasonable when compared with long-term wear observed in vehicle tests.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Effect of Break-In and Operating Conditions on Piston Ring and Cylinder Bore Wear in Spark-Ignition Engines


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    2004 Powertrain & Fluid Systems Conference & Exhibition ; 2004



    Erscheinungsdatum :

    25.10.2004




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Effect of break-in and operating conditions on piston ring and cylinder bore wear in spark-ignition engines

    Schneider,E.W. / Blossfeld,D.H. / General Motors Res.and Dev.Center,US | Kraftfahrwesen | 2004



    Effect of lubricant properties and lubricant degradation on piston ring and cylinder bore wear in a spark-ignition engine

    Schneider,E.W. / Blossfeld,D.H. / General Motors Res.and Dev.Center,US | Kraftfahrwesen | 2006


    Development of a piston ring-cylinder bore wear model

    Gangopadhyay,A. / Ford Motor,US | Kraftfahrwesen | 2000


    Abrasive wear of piston ring and cylinder bore materials

    Smith,C.A. / Davis,F.A. / Brunel University | Kraftfahrwesen | 1984