Tilt-table testing is one means of quantifying the static roll stability of highway vehicles. By this technique, a test vehicle is subjected to a physical situation analogous to that experienced in a steady state turn. Although the analogy is not perfect, the simplicity and fidelity of the method make it an attractive means for estimating static rollover threshold.The NHTSA has suggested the tilt-table method as one means of regulating the roll stability properties of light trucks and utility vehicles. One consideration in evaluating the suitability of any test method for regulatory use is repeatability, both within and among testing facilities. As a first step toward evaluating the repeatability of the tilt-table method, an experimental study examining the sensitivity of tilt-table test results to variables associated with methodology and facility was conducted by UMTRI for the Motor Vehicle Manufacturers Association. This paper reports some of the findings of that study.The test program examined the influence of twelve specific variables. The matrix of tests consisted of the baseline condition and thirty-three off-baseline conditions. One hundred and thirteen individual tilt-table tests were conducted on a single test vehicle. In general, the tilt-table method was found to be quite robust in that measurement results appeared to be rather insensitive to most of the variables considered. Surface friction under the low-side tires and trip rail geometry, when applicable, were the primary exceptions to this rule.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Repeatability of the Tilt-Table Test Method


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Winkler, C. B. (Autor:in) / Campbell, K. E. (Autor:in) / Bogard, S. E. (Autor:in)

    Kongress:

    International Congress & Exposition ; 1993



    Erscheinungsdatum :

    1993-03-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Repeatability of the tilt-table test method

    Winkler,C.B. / Bogard,S.E. / Campbell,K.E. et al. | Kraftfahrwesen | 1993


    Repeatability and Reliability of the Tube Suction Test

    Spencer Guthrie, W. / Ellis, Peter M. / Scullion, Tom | Transportation Research Record | 2001


    Repeatability of Offset Deformable Barrier Collision Test

    Tateishi, K. / Oyama, M. | British Library Online Contents | 1996


    General Motors Fog Test (GM9305P) Modified for Improved Repeatability

    Mulrenin, E.A. / Somers, N. | SAE Technical Papers | 1992


    DETERMINATION OF RESTRAINT EFFECTIVENESS - Airbag Crash Test Repeatability

    Versace, John / Berton, Roger J. | SAE Technical Papers | 1975