This SAE Standard specifies the major dimensions and tolerances for Engine Flywheel Housings and the Mating Transmission Housing Flanges. It also locates the crankshaft flange face or the transmission pilot bore (or pilot bearing bore) stop face in relation to housing SAE flange face. This document is not intended to cover the design of the flywheel housing face mating with the engine crankcase rear face or the design of housing walls and ribs. Housing strength analysis and the selection of housing materials are also excluded. This document applies to any internal combustion engine which can utilize SAE No. 6 through SAE No. 00 size flywheel housing for mounting a transmission. This technical report is being stabilized because it covers technology, products, or processes which are mature and not likely to change in the foreseeable future.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Engine Flywheel Housing and Mating Transmission Housing Flanges


    Erscheinungsdatum :

    2020-09-29



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch







    Engine flywheel housing sling

    KANG YUXIA / QIU YONGCHENG / SHEN ZHAOJIE et al. | Europäisches Patentamt | 2016

    Freier Zugriff

    ENGINE AND FLYWHEEL HOUSING

    HIRAO YU / MATSUO SHINYA | Europäisches Patentamt | 2023

    Freier Zugriff