In a previous SAE paper (940938) Huang and Gerdeen showed that there was very little experimental data available for springback of small radius-to-thickness bends, in the range R/t < 10, and that the data showed larger spring back than that predicted by any known theory. Due to this lack of data, additional experiments have been conducted on three steels: a F50, an IF, and an AKDQ steel. Results of these experiments are reported in this paper.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Springback of Sheet Metal Bent to Small Radius/Thickness Ratios


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Robertson, D. (Autor:in) / Gerdeen, J. C. (Autor:in) / Sanchez, L. R. (Autor:in)

    Kongress:

    International Congress & Exposition ; 1996



    Erscheinungsdatum :

    1996-02-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch


    Schlagwörter :


    Springback of sheet metal bent to small radius/thickness ratios

    Sanchez,L.R. / Robertson,D. / Gerdeen,J.C. et al. | Kraftfahrwesen | 1996


    Predicting the Radius of a Sheet Bent Around Drawbeads

    Levy, B. S. / Van Tyne, C. J. | SAE Technical Papers | 2009


    Thin Sheet Springback Optimal Assessment

    Constantin, I.C. / Epureanu, A. / Maier, C. et al. | British Library Conference Proceedings | 2008


    The Effect of Process Variables on Sheet Metal Springback

    Stein, Jared J. | SAE Technical Papers | 1998


    The Effect of Process Variables on Sheet Metal Springback

    Stein, J. J. / SAE | British Library Conference Proceedings | 1998