Drill geometry specifications, per industry standards, are insufficient to control a single-pass drilling process. For close tolerance holes, those having a tolerance band of 0.003 inch, cutting tool geometry must have additional requirements defined to ensure consistency in manufacturing processes. This paper addresses key characteristics and inspection methods required to control cutting tool performance and to ensure repeatability in an aerospace manufacturing environment.The primary intent of this paper is to raise the awareness in industry that higher quality product is required by end users.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Single-Pass Drilling of Composite/Metallic Stacks


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Born, Glenn G. (Autor:in)

    Kongress:

    2001 Automated Fastening Conference & Exposition ; 2001



    Erscheinungsdatum :

    2001-09-10




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    New Vibration System for Advanced Drilling Composite-Metallic Stacks

    K'nevez, Jean-Yves / Jallageas, Jeremy / Cherif, Mehdi et al. | SAE Technical Papers | 2013


    Process Speeds for Drilling and Reaming CFRP and CFRP/Metallic Stacks

    Barry, John / Uffelman, Zan | SAE Technical Papers | 2011