This paper describes a method and apparatus intended to minimize hydrocarbons (HC), carbon monoxide (CO), and nitric oxide (NO) in spark ignition engine exhaust by utilizing the unused displacement of the engine at part loads as an internal thermal reactor. The method used is to induct exhaust gas plus air into one portion of the cylinder and unthrottled fuel-air charge into the balance. The fuel-air charge is rich to minimize NO formation, but, as a result, the products of combustion contain HC and CO. Air is added to these products before re-induction to provide additional oxygen to complete the oxidation which is promoted by the high pressures and temperatures of compression and combustion. Load control is achieved by varying the relative amounts of fuel-air charge and recirculated exhaust.Experimentally, it was shown that the necessary stratification existed until the spark occurred but not thereafter. The very low NO concentrations expected were realized, but HC and CO values were higher than desired.This paper describes a method and apparatus intended to minimize hydrocarbons (HC), carbon monoxide (CO), and nitric oxide (NO) in spark ignition engine exhaust by utilizing the unused displacement of the engine at part loads as an internal thermal reactor. The method used is to induct exhaust gas plus air into one portion of the cylinder and unthrottled fuel-air charge into the balance. The fuel-air charge is rich to minimize NO formation, but, as a result, the products of combustion contain HC and CO. Air is added to these products before re-induction to provide additional oxygen to complete the oxidation which is promoted by the high pressures and temperatures of compression and combustion. Load control is achieved by varying the relative amounts of fuel-air charge and recirculated exhaust.Experimentally, it was shown that the necessary stratification existed until the spark occurred but not thereafter. The very low NO concentrations expected were realized, but HC and CO values were higher than desired.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    A Spark Ignition Engine with an In-Cylinder Thermal Reactor


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Jessel, A. J. (Autor:in) / Uyehara, O. A. (Autor:in) / Myers, P. S. (Autor:in)

    Kongress:

    Fleet Week ; 1973



    Erscheinungsdatum :

    01.02.1973




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    A turbocharged spark ignition engine with thermal reactor, performance and emission characteristics

    Goddard,S.J. / Jasper,B.C. / McWhannel,D.C. et al. | Kraftfahrwesen | 1978


    In-Cylinder Flow Measurements in a Transparent Spark Ignition Engine

    Chraniotis, Anastasios / Tourlidakis, Antonios / Kolokotronis, Dimitrios et al. | SAE Technical Papers | 2019


    In-Cylinder Flow Measurements in a Transparent Spark Ignition Engine

    Tsiogkas, Vasileios D. / Chraniotis, Anastasios / Kolokotronis, Dimitrios et al. | British Library Conference Proceedings | 2019



    Emissions from a Direct-Cylinder Water-Injected Spark-Ignition Engine

    Colony, C. M. / Lestz, S. S. / Meyer, W. E. | SAE Technical Papers | 1972