The influences of injector nozzle geometry, injection pressure and ambient air conditions on a diesel fuel spray were examined using back-lighting techniques. Both stills and high speed imaging techniques were used. Operating conditions representative of a modern turbocharged aftercooled HSDI diesel engine were achieved in an optical rapid compression machine fitted with a common rail fuel injector.Qualitative differences in spray structure were observed between tests performed with short and long injection periods. Changes in the flow structure within the nozzle could be the source of this effect.The temporal liquid penetration lengths were derived from the high-speed images. Comparisons were made between different nozzle geometries and different injection pressures. Differences were observed between VCO (Valve Covers Orifice) and mini-sac nozzles, with the mini-sac nozzles showing a higher rate of penetration under the same conditions.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    The Influence of Injector Parameters on the Formation and Break-Up of a Diesel Spray


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Crua, C. (Autor:in) / Kennaird, D. A. (Autor:in) / Wray, J. (Autor:in) / Heikal, M. R. (Autor:in) / Morgan, R. (Autor:in)

    Kongress:

    SAE 2001 World Congress ; 2001



    Erscheinungsdatum :

    2001-03-05




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    The influence of injector parameters on the formation and break-up of a diesel spray

    Morgan,R. / Wray,J. / Kennaird,D.A. et al. | Kraftfahrwesen | 2001


    Lattice Boltzmann modeling of diesel spray formation and break-up

    Falcucci,G. / Ubertini,S. / Bella,G. et al. | Kraftfahrwesen | 2010


    Lattice Boltzmann Modeling of Diesel Spray Formation and Break-Up

    De Maio, Alessandro / Falcucci, Giacomo / Bella, Gino et al. | SAE Technical Papers | 2010