Out-of-round holes are formed as a result of tool motion during drilling. Tool vibration is driven by radial and tangential forces on the primary and secondary cutting edges. These forces in turn depend on the chip loads on each cutting edge, which in turn depend on the position of the tool at the current time and at the time of the previous tooth passage. A preliminary analysis based on balancing the cutting forces and the bending forces on the tool, shows that the characteristic frequencies of motion of the tool in the tool frame are near 3/rev, 5/rev, 7/rev etc. (corresponding to 2/rev, 4/rev, 6/rev) in the workpiece frame. These motions are consistent with the tool motion and hole form errors commonly observed on the shop floor. We will describe procedures for measuring the dependence of cutting forces on chip load, the development of simple equations for lateral motion of the tool, and solutions for the tool's behavior.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Radial and Tangential Forces, Tool Motion, and the Formation of Lobed Holes in Drilling


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    2002 SAE Automated Fastening Conference & Exhibition ; 2002



    Erscheinungsdatum :

    30.09.2002




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Radial and Tangential Forces, Tool Motion, and the Formation of Lobed Holes in Drilling

    Dilley, D. N. / Bayly, P. V. / Martinek, B. J. et al. | British Library Conference Proceedings | 2002


    LOBED NUT CAP

    DOBBIN RICHARD | Europäisches Patentamt | 2017

    Freier Zugriff

    Lobed track pin

    MCKINLEY TIMOTHY ALLEN / HU ZHIYONG / TIAN WEIXUE et al. | Europäisches Patentamt | 2019

    Freier Zugriff

    LOBED TRACK PIN

    MCKINLEY TIMOTHY A / HU ZHIYONG / TIAN WEIXUE et al. | Europäisches Patentamt | 2021

    Freier Zugriff

    Lobed nut cap

    RICHARD DOBBIN | Europäisches Patentamt | 2016

    Freier Zugriff