Pumping Mean Effective Pressure (PMEP) is the main factor limiting the improvement of thermal efficiency in a spark-ignition (SI) engine under low load. One of the ways to reduce the pumping loss under low load is to use Cylinder DeActivation (CDA). The CDA aims at reducing the firing density (FD) of the SI engine under low load operation and increasing the mass of air-fuel mixture within one cycle in one cylinder to reduce the throttling effect and further reducing the PMEP. The multi-stroke cycles can also reduce the firing density of the SI engine after some certain reasonable design, which is feasible to improve the thermal efficiency of the engine under low load in theory. The research was carried out on a calibrated four-cylinder SI engine simulation platform. The thermal efficiency improvements of the 6-stroke cycle and 8-stroke cycle to the engine performance were studied compared with the traditional 4-stroke cycle under low load conditions. The simulation results showed that multi-strokes consumed less energy in pumping loss and heat transfer loss compared with the four-stroke cycle, but more in frictional loss and exhaust energy loss. The relationship between the two groups influences the improvement in thermal efficiency. When the average torque was lower than 70Nm, the eight-stroke cycle had the most obvious improvement on Brake Specific Fuel Consumption (BSFC), and the maximum increase was 25.6%, which was higher than the low-pressure six-stroke cycle (LSC) and the high-pressure 6-stroke cycle (HSC). However, the optimization range of thermal efficiency and the power range of different stroke cycles influenced each other. The stronger the optimization effect was, the narrower the corresponding power range was.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    A Comparison Study on the Performance of the Multi-Stroke Cycle SI Engine under Low Load


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Zhao, Hua (Autor:in) / Chen, Tao (Autor:in) / Lin, Weipeng (Autor:in) / Feng, Yifang (Autor:in) / Wang, Yu (Autor:in) / Yao, Zhuoxiao (Autor:in)

    Kongress:

    SAE WCX Digital Summit ; 2021



    Erscheinungsdatum :

    2021-04-06




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Comparison of an E10 Direct Injection Two-Stroke Cycle Engine and an E85 Four-Stroke Cycle Engine

    Oswald, Adam / Fleming, Brian / Hickok, Brian et al. | SAE Technical Papers | 2003


    Two stroke cycle engine cylinder

    Kenny,R.G. / Smyth,J.G. / Fleck,R. et al. | Kraftfahrwesen | 1989


    Schliha two-stroke-cycle engine

    Baechler, H. | Engineering Index Backfile | 1928


    Four Stroke Cycle Engine Development

    Satoh,K. / Niigata Engng.,JP | Kraftfahrwesen | 1979


    Evaluation of High Performance Two-Stroke Cycle Engine Lubricants

    Callis, G. E. / Sytz, W. E. | SAE Technical Papers | 1984