This paper addresses the need for fundamental understanding of the mechanisms of fuel spray formation and mixture preparation in direct injection spark ignition (DISI) engines. Fuel injection systems for DISI engines undergo rapid developments in their design and performance, therefore, their spray breakup mechanisms in the physical conditions encountered in DISI engines over a range of operating conditions and injection strategies require continuous attention. In this context, there are sparse data in the literature on spray formation differences between conventionally drilled injectors by spark erosion and latest Laser-drilled injector nozzles. A comparison was first carried out between the holes of spark-eroded and Laser-drilled injectors of same nominal type by analysing their in-nozzle geometry and surface roughness under an electron microscope. Then the differences in their spray characteristics under quiescent conditions, as well as in a motoring optical engine, are discussed on the basis of high-speed imaging experiments and image processing methods. Specifically, the spray development mechanism was quantified by spray tip penetration and cone angle data under a range of representative low-load and high-low engine operating conditions (0.5 bar and 1.0 bar absolute, respectively), as well as at low and high injector body temperatures (20 °C and 90 °C) to represent cold and warm engine-head conditions. Droplet sizing was also performed with the two injectors using Phase Doppler Anemometry in a quiescent chamber.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Characterisation of Spray Development from Spark-Eroded and Laser-Drilled Multi-Hole Injectors in an Optical DISI Engine and in a Quiescent Injection Chamber


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Butcher, A.J. (Autor:in) / Richardson, David (Autor:in) / Aleiferis, P.G. (Autor:in)

    Kongress:

    JSAE/SAE 2015 International Powertrains, Fuels & Lubricants Meeting ; 2015



    Erscheinungsdatum :

    2015-09-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Spray Formation from Spark-Eroded and Laser-Drilled Injectors for DISI Engines with Gasoline and Alcohol Fuels

    Behringer, M. / Aleiferis, P. / OudeNijeweme, D. et al. | British Library Conference Proceedings | 2014


    Spray Formation from Spark-Eroded and Laser-Drilled Injectors for DISI Engines with Gasoline and Alcohol Fuels

    OudeNijeweme, Dave / Behringer, Markus / Freeland, Paul et al. | SAE Technical Papers | 2014


    Multi-hole Injectors for DISI Engines: Nozzle Hole Configuration Influence on Spray Formation

    Dahlander, Petter / Lindgren, Ronny | SAE Technical Papers | 2008


    Multi-hole injectors for DISI engines: nozzle hole configuration influence on spray formation

    Dahlander,P. / Lindgren,R. / Chalmers Univ.of Technology,SE | Kraftfahrwesen | 2008


    Development of Multi-hole Nozzle Injector for Spray-guided DISI Engine

    Tanaka, Makoto / Shigenaga, Masahiro / Yamamoto, Norio et al. | SAE Technical Papers | 2011