High-pressure multi-hole injectors are one candidate injector type for closed-spaced direct injection (DI) gasoline engines. In such a system, the spark plug must be located close to the spray and, during stratified operation, the spray is ignited very soon after the fuel droplets have been vaporized. Thus there are very high demands on the sprays used in such a system. An additional challenge is the positioning of the spark plug relative to the spray; both consistent ignitability and the absence of liquid fuel droplets must be achieved. Many injector parameters influence spray formation; for example, hole diameter, length to hole diameter ratio, nozzle hole configuration etc.This paper investigates the spray formation and spray induced air movement associated with rotational symmetrical and asymmetrical nozzle hole configurations. Four different nozzles with different hole configurations and umbrella angle were investigated both experimentally and numerically in a heated/pressurized spray chamber. Their influence on spray formation, spray induced air motion, cross-flow velocity, fuel/air ratio, turbulence and cycle-to-cycle variations were studied. It was found that rotational symmetrical configurations produce non-coherent isolated clouds of fuel. If an asymmetrical configuration is used instead (holes positioned along a horseshoe-shaped arc) then, by choosing the injector configuration carefully, it is easier to obtain a coherent fuel cloud; this also facilitates better control over the conditions at the spark plug, for example the fuel/air ratio, cross-flow velocity and turbulence. Furthermore, asymmetrical nozzles benefit from smaller fuel gradients and enhanced mixing between spray plumes as a result of shorter spray plume distance and improved spray-induced air motion. All the nozzles tested produced partially premixed vapor clouds, with cycle-to-cycle variations. These variations may be an important issue for ignition stability in a closed-spaced combustion system.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Multi-hole Injectors for DISI Engines: Nozzle Hole Configuration Influence on Spray Formation


    Weitere Titelangaben:

    Sae Int. J. Engines


    Beteiligte:

    Kongress:

    SAE World Congress & Exhibition ; 2008


    Erschienen in:

    Erscheinungsdatum :

    2008-04-14


    Format / Umfang :

    14 pages




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Multi-hole injectors for DISI engines: nozzle hole configuration influence on spray formation

    Dahlander,P. / Lindgren,R. / Chalmers Univ.of Technology,SE | Kraftfahrwesen | 2008


    Development of Multi-hole Nozzle Injector for Spray-guided DISI Engine

    Tanaka, Makoto / Shigenaga, Masahiro / Yamamoto, Norio et al. | SAE Technical Papers | 2011


    Spray guided DISI using side mounted multi-hole injector

    Yamashita,H. / Seto,M. / Ota,N. et al. | Kraftfahrwesen | 2007


    Spray Guided DISI Using Side Mounted Multi-Hole Injector

    Yamamoto, Hiroyuki / Yamashita, Hiroyuki / Seto, Masatoshi et al. | SAE Technical Papers | 2007


    Characteristics of Nozzle Internal Flow and Near-Field Spray of Multi-Hole Injectors for Diesel Engines

    Shimo, Daisuke / Nishida, Keiya / Namba, Makoto et al. | SAE Technical Papers | 2015