The purpose of this SAE Recommended Practice is to provide standardized dimensions for mounting starting motors. (See Figures 1 through 4.) It is recommended that a full register diameter having a minimum depth of 2.54 mm (0.100 in) be provided in the flywheel housing to insure proper control of gear center distance and clearance between pitch diameters. The clearance between the starting motor pilot diameter and the register diameter in the flywheel housing should be 0.03 mm (0.001 in) minimum to 0.25 mm (0.010 in) maximum. Text noted with an asterisk in Figures 1, 2, and 3, should not exceed root radius of pinion in order to provide clearance for the flywheel. The face of the starting motor mounting flange should be relieved at its junction with the pilot diameter to avoid mounting interference with flywheel housing. For backlash allowance between the pinion and ring gear refer to SAE J543. Dimensional units—millimeter (inch) Not applicable.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    STARTING MOTOR MOUNTINGS


    Erscheinungsdatum :

    01.06.1991



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    STARTING MOTOR MOUNTINGS

    SAE Technical Papers | 1987


    STARTING MOTOR MOUNTINGS

    SAE Technical Papers | 1978


    CRANKSHAFT DAMPENING AND MOTOR MOUNTINGS

    Peirce, Thomas H. | SAE Technical Papers | 1938


    ENGINE MOUNTINGS

    SAE Technical Papers | 1985


    ENGINE MOUNTINGS

    SAE Technical Papers | 1991