This paper is based on a Research Project of the Department of Mechanical Engineering (DiME) in collaboration with Aprilia, the Italian motorbike manufacturer. In an attempt to simulate the functioning of the cooling plant of the Aprilia RSV-4 motorbike a numerical model was constructed using mono-dimensional and three-dimensional simulation codes. Our ultimate aim was to create a simulation model which could be of assistance to engine designers to improve cooling plant performance, thereby reducing research and development costs. The model allows to simulate the running conditions of the whole cooling circuit upon variations in environmental and running conditions.In particular, the centrifugal pump of the cooling plant was simulated by a 3D commercial software, while the whole circuit was built by a 1D commercial code which allows simulation of all the thermal exchanges and pressure drops in the cooling circuit._An experimental campaign was also performed to obtain data to properly set and tune the numerical model. The cooling circuit was instrumented by thermocouples and pressure transducers in several points, and the motorbike was installed on a motorbike test bench, where several tests, in steady and transient conditions, and in different engine running conditions were performed.
Analysis of the Cooling Plant of a High Performance Motorbike Engine
Sae Technical Papers
SAE 2012 World Congress & Exhibition ; 2012
2012-04-16
Aufsatz (Konferenz)
Englisch
Analysis of the cooling plant of a high performance motorbike engine
Kraftfahrwesen | 2012
|Analysis of the Cooling Plant of a High Performance Motorbike Engine
British Library Conference Proceedings | 2012
|High Performance Motorbike Engine Block Structural Calculation
SAE Technical Papers | 2005
|Motorbike power supply circuit, motorbike power supply system and motorbike
Europäisches Patentamt | 2015
|