Assuming that large high temperature resistant composites will primarily be cured in autoclaves, an immediate requirement for suitable autoclave tooling exists. The Wichita State University - Institute for Aviation Research (WSU-IAR) is conducting high temperature tooling studies. The approach is to build tooling from a polymer/graphite composite which will correlate with the thermal expansions of the composite being molded. Detailed information is shared on the development of master models, intermediary models and other sequential tooling steps. Finally, the paper shares the molding results with advanced thermoplastic composites.
Aytoclawe Tooling for Thermoplastic/Graphite Composites
Sae Technical Papers
General Aviation Aircraft Meeting and Exposition ; 1989
1989-04-01
Aufsatz (Konferenz)
Englisch
Low-Cost Materials for Thermoplastic Composite Tooling
AIAA | 2024
|Graphite/Thermoplastic-Pultrusion Die
NTRS | 1990
|Metal spray Invar tooling for composites
Emerald Group Publishing | 2000
|Low cost tooling for composites system
Emerald Group Publishing | 2003