To improve the speed and accuracy of engine testing, the spark (gasoline)/injection (diesel) timing can be optimized based on the location of the 50% mass fraction burn point (α50) rather than the traditional approach of "sweeping" timing to find the most efficient point. Results from both gasoline and diesel engines show that setting α50 to around 8° ATDC gives optimum efficiency for most circumstances. An exception is the case of highly unstable combustion, where the misfire rate may also be strongly dependent on timing. For diesel engines this method is effective in finding the timing for best efficiency but in practice the chosen injection timing may be driven more by the need to optimize emissions.This technique has been implemented by incorporating a burn angle controller into the MAHLE Flexible ECU (MFE), a powerful and highly adaptable engine controller. The MFE includes the burn angle calculation (based on cylinder pressure signals) as well as the main control strategy in a single robust unit, allowing for straightforward test bed or vehicle operation of gasoline and diesel engines. The burn angle controller also takes account of knock and cylinder pressure limitations.A high octane fuel demonstrator car was developed using the MFE for the remapping of spark and other parameters. Optimum spark timing was found by the burn angle controller while operating the engine at different loads and speeds on a chassis dynamometer, without needing to remove the engine from the vehicle. The remapped engine delivered 15-20% more torque at low to medium speeds than the baseline engine (at the same boost pressure), while reducing fuel requirement due to lower exhaust temperatures. This could be felt as much stronger vehicle performance and improved flexibility in high gears.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Improving Speed and Accuracy of Gasoline and Diesel Engine Testing via Closed-Loop Combustion Control


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Pates, David (Autor:in) / Warth, Marco (Autor:in) / Cains, Tony (Autor:in)

    Kongress:

    SAE 2012 World Congress & Exhibition ; 2012



    Erscheinungsdatum :

    16.04.2012




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Improving Speed and Accuracy of Gasoline and Diesel Engine Testing via Closed-Loop Combustion Control

    Cains, T. / Pates, D. / Warth, M. et al. | British Library Conference Proceedings | 2012


    Closed-Loop Control for Diesel Combustion Noise Using Engine Vibration Signals

    Jung, Insoo / Jin, Jaemin / Won, Kwangmin et al. | British Library Conference Proceedings | 2015


    Closed-Loop Control for Diesel Combustion Noise Using Engine Vibration Signals

    Choi, Hoimyung / Jung, Insoo / Jin, Jaemin et al. | SAE Technical Papers | 2015


    Closed-Loop Control Method for Monitoring and Improving the Diesel Combustion Noise

    Lee, Dongchul / Jung, Insoo / Jin, Jaemin et al. | SAE Technical Papers | 2016


    Diesel Engine Cycle to Cycle Feed-forward plus Closed-loop Combustion Control

    Ventura, Loris / Manelli, Andrea / Malan, Stefano | BASE | 2021

    Freier Zugriff