Structural system identification was applied to small sample problems and to large automotive structures. The technique combines mass and stiffness matrices from a finite element model with experimental mode shapes and natural frequencies to produce improved mass and stiffness matrices. In numerical experiments on small problems the procedure enabled us to identify regions of original finite element models where changes of model parameters were required to bring finite element predictions into better agreement with exact results. Also, node point displacements were calculated for small structures subjected to time-dependent sinusoidal loads, and it was found that predictions of displacements from “improved” models were more accurate than original finite element model predictions when forcing frequencies were within the range of experimental frequencies used with structural system identification calculations. When applied to two large automotive structures. regions within the finite element models identified as candidates for parameter changes to, in one case, bring about a shift in predicted frequencies, and, in the other case, improve correlation with test results, were found to be consistent with our engineering judgement.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Procedures of Structural System Identification Applied to Automotive Structures


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Butkunas, A. A. (Autor:in) / Flanigan, D. L. (Autor:in) / Ciarelli, D. M. (Autor:in) / Dorenbaum, J. V. (Autor:in) / Kline, K. A. (Autor:in) / Riesner, M. (Autor:in) / Surulinarayanasami, P. (Autor:in)

    Kongress:

    6th International Conference on Vehicle Structural Mechanics and Exposition ; 1986



    Erscheinungsdatum :

    22.04.1986




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch


    Schlagwörter :