Numerous authors have previously published on the effects of system dynamics on gear noise in automotive applications [1,2]. It is now widely understood that the torsional compliances and inertias of propeller shafts and pinion gear sets are a controlling factor in final drive gear noise for rear wheel drive vehicles. Considerable progress has been achieved in using finite element simulations of the driveline dynamics to improve the system in regards to gear noise. However very few published results are available showing the application of dynamic simulation methods to automatic transmissions which require considerations of the complications due to epicyclical gear sets.This paper documents the successful application of finite element dynamics modeling methods to the prediction of gear noise from the gear set in a rear wheel drive automatic transmission. The model was used to investigate the effects of component inertias, stiffnesses, and resonances. Specifically, the ring gear and shaft resonances and the tail stock housing stiffness were found to be significant design factors which influence the gear whine.Model construction issues will be discussed as well as correlation of predicted gear noise traces with operating measurements. Finally, a comparison will be provided of the noise reduction achieved by incorporating the recommended design modifications into prototype hardware.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Gear Noise Reduction of an Automatic Transmission Through Finite Element Dynamic Simulation


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Campbell, Brian (Autor:in) / Steyer, Glen (Autor:in) / Clapper, Mark (Autor:in) / Gagnon, Nancy (Autor:in) / Krishnaswami, R. (Autor:in) / Stokes, Wayne (Autor:in)

    Kongress:

    SAE Noise and Vibration Conference and Exposition ; 1997



    Erscheinungsdatum :

    20.05.1997




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Gear Noise Reduction of an Automatic Transmission Through Finite Element Dynamic Simulation

    Campbell, B. / Stokes, W. / Steyer, G. et al. | British Library Conference Proceedings | 1997


    Gear noise reduction of an automatic transmission through finite element dynamic simulation

    Campbell,B. / Stokes,W. / Steyer,G. et al. | Kraftfahrwesen | 1997


    Gear noise reduction through transmission error control and gear blank dynamic tuning

    Chung,C.H. / Steyer,G. / Abe,T. et al. | Kraftfahrwesen | 1999


    Gear Noise Reduction through Transmission Error Control and Gear Blank Dynamic Tuning

    Shah, Chandra / Chung, Chih-Hung (Jerry) / Steyer, Glen et al. | SAE Technical Papers | 1999


    Gear noise simulation using a displacement based finite element method

    Nurhadi,I. / Seireg,A. / Bandung Inst.of Technology,KR et al. | Kraftfahrwesen | 1987