A theoretical stress analysis was performed on the crankshaft of a 2-cyl engine using routine engineering calculations, and the results were verified by test. Agreement was satisfactory under controlled operating conditions. Actual service loads were found to be about half as high as the maximum possible. The fatigue strength of production crankshafts was measured in a specially built fixture. About 20-30% improvement in fatigue strength could be achieved by shot peening or Tufftride. A theoretical stress analysis was performed on the crankshaft of a 2-cyl engine using routine engineering calculations, and the results were verified by test. Agreement was satisfactory under controlled operating conditions. Actual service loads were found to be about half as high as the maximum possible. The fatigue strength of production crankshafts was measured in a specially built fixture. About 20-30% improvement in fatigue strength could be achieved by shot peening or Tufftride.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Stress and Fatigue Analysis of a Two Throw Crankshaft


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    1967 Automotive Engineering Congress and Exposition ; 1967



    Erscheinungsdatum :

    01.02.1967




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Enhanced crankshaft stress calculation method and fatigue life evaluation

    Rasser,M.W. / Resch,T. / Priebsch,H.H. et al. | Kraftfahrwesen | 1998


    Fatigue Life Analysis of Crankshaft at Various Surface Treatments

    Park, Hyounsoo / Jung, Seung Cheal / Ko, Young Sang | SAE Technical Papers | 2001


    Fatigue life analysis of crankshaft at various surface treatments

    Park,H. / Ko,Y.S. / Jung,S.C. et al. | Kraftfahrwesen | 2001


    Dynamic load and stress analysis of a crankshaft

    Montazersadgh,F.H. / Fatemi,A. / Univ.of Toledo,ES | Kraftfahrwesen | 2007


    Lubrication analysis of crankshaft bearing considering crankshaft deformation

    Sun,J. / Zhao,X. / Wang,H. et al. | Kraftfahrwesen | 2011