A case study of the application of shape optimization technique to the design of the third cross-member of an automotive chassis has been presented. Its fundamental frequency is only marginally higher than the maximum operating frequency of the transmission and drive shaft, which are mounted on this cross-member. The objective is to raise the cross-member frequency as high as possible so that there is no resonance and resulting fatigue damage. A sizing optimization indicated that the mass was a predominant factor. Shape optimization using approximate direct linearization method was performed and a number of design directions were obtained. The fundamental frequency of the cross-member was raised by about 4 Hz.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Chassis Cross-Member Design Using Shape Optimization - A Case Study


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    International Congress & Exposition ; 1998



    Erscheinungsdatum :

    23.02.1998




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Chassis cross-member design using shape optimization - a case study

    Krishna,M.M. / Dana,US | Kraftfahrwesen | 1998


    Chassis leg member

    ERVIN SIMON / JOHN QUINN | Europäisches Patentamt | 2017

    Freier Zugriff

    Carbon fiber cross member for automotive chassis structure

    PESCHANSKY LEN V / BURGER FRANK / YAGI YUTAKA et al. | Europäisches Patentamt | 2015

    Freier Zugriff

    ONE-PIECE CROSS-MEMBER FOR CARRIER TRUCK CHASSIS

    ZORLU FATIH ZAFER / AYAN SADIK MUTLU / KUMAS ALI et al. | Europäisches Patentamt | 2019

    Freier Zugriff

    Exploring New Joining Techniques of CFRP Cross Member Chassis

    Choi, Byeung Hyeun / Krsikapa, Daniel / Kim, Il Yong et al. | SAE Technical Papers | 2022