There is no standard equivalent to this SAE Standard. However, SAE J2226 is similar to and represents an extension of SAE J1998 (equivalent to ISO Standard 6622/2 TR). This SAE Standard specifies the essential dimensional features of Type B barrel faced steel rectangular piston rings. Only fully faced and inlaid coated rings are included, consistent with current U.S. practice. The requirements of this SAE Standard apply to steel piston rings of reciprocating internal combustion engines, up to and including 200 mm diameter and 4.5 mm width. Tolerances specified in this document represent a six sigma quality level.SAE J2226 is being discontinued because the content of this standard is also contained in ISO 6622-2. Therefore, to eliminate duplication and confusion in coordinating the standards between ISO and SAE, this document will be discontinued. The SAE Piston and Ring Standards committee will now continue to support ISO in updating the standards as appropriate.
Internal Combustion Engines--Piston Rings--Steel Rectangular Rings
2008-06-30
Aufsatz (Konferenz)
Englisch
INTERNAL COMBUSTION ENGINES—PISTON RINGS—STEEL RECTANGULAR RINGS
SAE Technical Papers | 1998
INTERNAL COMBUSTION ENGINES - PISTON RINGS - RECTANGULAR RINGS
SAE Technical Papers | 1989
INTERNAL COMBUSTION ENGINES—PISTON RINGS—RECTANGULAR RINGS
SAE Technical Papers | 1992
Internal Combustion Engines--Piston Rings--Rectangular Rings
SAE Technical Papers | 2008
Internal Combustion Engines—Piston Rings—Rectangular Rings
SAE Technical Papers | 1998