This work is about design of a static test stand for aeronautical engines with propeller. The objective is measure propeller thrust and engine torque (two degree of freedom). The design covers system specifications, structural design, dynamic analysis, instrumentation project and tests and calibration procedures. It specifies maximum forces to be measured, maximum propeller diameter and types of tests, as constant rotation, acceleration and robustness. Also, it is presented design recommendations covering structural loads, joint types, engine accessories and minimum instrumentation. A stand sketch is showed and calibration procedures were discussed. To forecast the system resonance frequency and dynamic behavior, plots of stand-sensors system dynamic response were presented. This test stand allows measuring propeller static efficiency and engine-propeller system static propulsive curve.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Design of an Aeronautical Engine Test Stand


    Weitere Titelangaben:

    Sae Technical Papers



    Kongress:

    International Mobility Technology Conference and Exhibit ; 2000



    Erscheinungsdatum :

    01.12.2000




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    AERONAUTICAL ENGINE BAG

    Europäisches Patentamt | 2018

    Freier Zugriff

    AERONAUTICAL ENGINE BAG

    Europäisches Patentamt | 2018

    Freier Zugriff

    Conception of Modular Test Stand for Fatigue Testing of Aeronautical Structures

    Leski, Andrzej / Wronicz, Wojciech / Kowalczyk, Piotr et al. | Springer Verlag | 2019



    Modular Test Stand for Fatigue Testing of Aeronautical Structures – Verification of Assumptions

    Leski Andrzej / Wronicz Wojciech / Kowalczyk Piotr et al. | DOAJ | 2020

    Freier Zugriff